Vulture mill machine and machine of vulture mill center have what difference

  • Time:
  • Click:210
  • source:WINNERS CNC Machining
Dispatch of net of machine tool of Chinese numerical control: Vulture mill machine and machine of vulture mill center have what difference: Machine of vulture mill center must install a knife the library moves the main shaft that lock up a knife compatibly, can change automatically according to the program in executive machine program knife, right the knife. And uneasiness of vulture mill machine assembles knife library, dan Kean installs pneumatic to lock up knife main shaft. Vulture mill machine basically used the technology of two respects, it is system of high-speed numerical control, gain of exalted buy annulus, the outline precision that assured treatment thereby is in the consistency of high low speed; It is mechanical part on the other hand fixed component if the acceleration of counteractive motion component pounds the tall rigid enough such as lathe bed, beam, pillar, and mobile component is like the should deft, high spirit such as workbench live. Brief introduction of happy letter photoelectricity issues the requirement of vulture mill machine to options, component and fittings below: To options: Be like full automatic the necessary options that is vulture mill machine to knife device, it can measure cutting tool length accurately (0.

002mm less than) , improve efficiency thereby, decrease to make mistake artificially opportunity, fall the trace that receive a knife to lowest. Those who want an attention is vulture mill machine those who go up is full automatic what go up to knife device and CNC Milling is different, because use very small cutting tool sometimes (like 0.

1mm) or the broach under 1mm, be opposite so knife nowadays pressure must small, use next pressure to be less than commonly 0.

Of 8N full automatic to Dao Yi. To the component: Want to accord with the requirement that high rate, high accuracy machines. If high speed main shaft uses 2 kinds commonly, one kind is in 1-2.

The main shaft of report of direct form high speed that 2kw less than uses, rotate speed is in 36, 000RPM is the following, cutting is torsional for 1-2N, use air cooling means commonly. Another kind is in 2.

2-7.

5kw less than uses inside main shaft of report of high speed Tibetan type, rotate speed is in 30, 000RPM is the following, cutting is torsional for 3-9N, use water-cooling commonly. To fittings: If circular knife grinding machine is mixed,measure microscope should special attention. Circular knife grinding machine is necessary long grind tool machine, with measure microscope to cooperate to use. The CBN emery wheel of circular knife grinding machine is very crucial, general kibble uses 300 or so can, and essence of life is ground must use 1, 200 emery wheel. Measure microscope to must scale watch measures length of point of a knife and point of view accurately, normally manufacturer should form a complete set is offerred, a bit must emphasize: Measuring a knife to grind a knife is a of treatment important segment, the dimension deviation that uses numerical control machine tool, cutting tool must is less than 0.

01mm. CNC Milling